Automotive Diagnostic Softare

GM MDI Chevrolet Cruze Calibration Update Guide

dave1987 | 03 December, 2019 03:28

 

Purpose:
Perform GM SPS (Service Programming System) Programming J2534 mode for instrument panel controller (IPC) calibration updates using GM MDI scan tool (original or a good high quality clone).
This can be for the ECU or any programmable module in the vehicle, such as the EBCM, TCM, Radio, or IPC that you may want to reflash.
Model example: Chevrolet Cruze Passenger car 2012
(Applicable to model year 2011 and up, which is when the Tech2 ended and was fully replaced by the GM Multiple Diagnostic Interface, or MDI and MDI 2, and TIS2Web subscriptions.) 
What you need to program:
High Quality GM MDI clone with WiFi
A laptop
GM online subscription (or https://www.acdelcotds.com/subscriptions)
GM MDI SPS Programming J2534 Mode ECU TIS2Web Calibration Update:
Select SPS programming->Start SPS
gm-mdi-sps-programming-calibration-update-1

gm-mdi-sps-programming-calibration-update-2

Select Interface as J2534 MDI and programming process: Reprogram ECU
gm-mdi-sps-programming-calibration-update-3

Connect J2534 device (GM MDI interface) to vehicle and PC
gm-mdi-sps-programming-calibration-update-4

gm-mdi-sps-programming-calibration-update-5

Turn ignition off
verify vehicle battery fully charged
Turn ignition on, engine off
Connect J2534 device to Data Link Connector
Connect J2534 device to PC
Switch J2534 mdi on and wait for MDI  to get ready
After programming erase all DTC of all ECUs
After communication is built, select vehicle model
gm-mdi-sps-programming-calibration-update-6
Chevrolet Cruze Passenger car 2012
gm-mdi-sps-programming-calibration-update-7

Display and confirm VIN
gm-mdi-sps-programming-calibration-update-8
gm-mdi-sps-programming-calibration-update-9

Select control module, function and type to reflash
–IPC Instrument Cluster
–Programming
–Normal programming type
gm-mdi-sps-programming-calibration-update-10
Check current calibration version and available update
gm-mdi-sps-programming-calibration-update-11

gm-mdi-sps-programming-calibration-update-12

gm-mdi-sps-programming-calibration-update-13
Perform new software for Trip Timer update
gm-mdi-sps-programming-calibration-update-14
During programming procedure, the dashboard turns black which is normal
gm-mdi-sps-programming-calibration-update-15

gm-mdi-sps-programming-calibration-update-16
Wait until the programming process count down to 0
gm-mdi-sps-programming-calibration-update-17
Turn off the key for 30 seconds and then back on to complete the programming reset the controller.  Dashboard turns on.
gm-mdi-sps-programming-calibration-update-18
IPC calibration update completed.
gm-mdi-sps-programming-calibration-update-19
Record the code and erase all fault codes existed.
Done.
http://blog.obdii365.com/2019/12/02/gm-mdi-chevrolet-cruze-calibration-updates-via-sps-programming/

 

 
Provided by Multiblog.net - easy blogging platform
P0wered by L1fe7ype - De51gn by Ba1earWe6